2024 United States National Committee of URSI National Radio Science Meeting (USNC-URSI NRSM), (Boulder, CO, USA, 2024, 225-226)

Preliminary Mid-Band Troposcatter Measurement Results Using Different High-Gain Receiver Antennas

doi: 10.23919/USNC-URSINRSM60317.2024.10464674

Cite This Publication

Adam C. Hicks ORCID logo, Google Scholar logo, Scopus logo, Web of Science logo, James McLean, and John D. Ewan

Abstract:

This article provides initial results of measurements made to assess the influence that different antenna patterns have on the received signal level of a mid-band troposcatter radio link. Measurements were performed at 3.475 GHz over a 185 km troposcatter link in Colorado with two vertically polarized receiver antennas: standard gain horn and parabolic dish. Median values of basic transmission loss (BTL) are compared for the two antennas. Cumulative distribution functions (CDFs) of hourly median BTL are plotted against predictions from the Institute for Telecommunications Sciences, Irregular Terrain Model (ITM). BTL measurements with the standard gain horn (219.77 dB median and 8.73 dB standard deviation) show better comparison with ITM predictions (214 dB median., and approximately 7.8 dB standard deviation) than BTL measurements made with the parabolic dish (228.21 dB median and 8.67 dB standard deviation). Further measurements and modeling are needed to explain these differences.

Keywords: propagation modeling; antennas; radio link; antenna measurements; receiving antennas; predictive models; transmitting antennas; test and validation; horn antennas; gain measurement; measurement design

For technical information concerning this report, contact:

Adam C. Hicks
Institute for Telecommunication Sciences

Disclaimer: Certain commercial equipment, components, and software may be identified in this report to specify adequately the technical aspects of the reported results. In no case does such identification imply recommendation or endorsement by the National Telecommunications and Information Administration, nor does it imply that the equipment or software identified is necessarily the best available for the particular application or uses.

For questions or information on this or any other NTIA scientific publication, contact the ITS Publications Office at ITSinfo@ntia.gov or 303-497-3572.

Back to Search Results