October 2000 | Technical Report TR-00-381
Flexible Interoperable Transceiver (FIT) Program Test Range II: Radio Propagation Measurements at 440, 1360 and 1920 MHz, Ft. Hood, Texas
Cite This Publication
Peter B. Papazian, Perry F. Wilson, Michael G. Cotton, and Yeh Lo, “Flexible Interoperable Transceiver (FIT) Program Test Range II: Radio Propagation Measurements at 440, 1360 and 1920 MHz, Ft. Hood, Texas,” Technical Report TR-00-381, U.S. Department of Commerce, National Telecommunications and Information Administration, Institute for Telecommunication Sciences, October 2000.
Peter B. Papazian, Perry F. Wilson, Michael G. Cotton , , , , and Yeh Lo
Abstract:
Radiowave propagation measurements at Ft. Hood, Texas are described. These measurements were made as part of the Flexible Interoperable Transceiver (FIT) Program. The objective of the measurements is to define communication link requirements at 440, 1360, and 1920 MHz. Simultaneous wideband measurements at three frequencies were made using fixed transmitters and a mobile fitted with a multi-channel receiver. The system measured the radio channel impulse response. Data outputs include delay spread and basic transmission loss. These parameters are compared at the three measurement frequencies to determine additional propagation impairments military systems will suffer due to frequency translation from 440 MHz to 1360 MHz and 1920 MHz.
Keywords: impulse response; basic transmission loss; radio wave propagation; delay spread; Flexible Interoperative Transceiver; FIT
For technical information concerning this report, contact:
Linh P. Vu
LVu@ntia.gov
Disclaimer: Certain commercial equipment, components, and software may be identified in this report to specify adequately the technical aspects of the reported results. In no case does such identification imply recommendation or endorsement by the National Telecommunications and Information Administration, nor does it imply that the equipment or software identified is necessarily the best available for the particular application or uses.
For questions or information on this or any other NTIA scientific publication, contact the ITS Publications Office at ITSinfo@ntia.gov or 303-497-3572.